The Smart Marty Sky Dispatch

Worldwide AviationSmartMarty.ca
General Aviation

Bugs in the System

A forgotten pitot cover in the high desert turns into a real-world lesson on redundant instruments and clearing blocked lines.

Bugs in the System
Featured aviation image for this report.

We had to leave our Dream Tundra on the ramp in Bishop, California, for a week. Bishop is high desert country, not a lot of moisture, not a lot of critters. Somehow, the pitot cover had been left at home, and an old battery coupled to a hot start led to leaving the airplane for future retrieval. That retrieval was this morning when a neighbor gave me a ride down to install a new battery and bring the airplane home. The battery replacement took 5 minutes—leaving a tin of homemade cookies for the Bishop Airport folks (who helped out on the day of “stranding”) took another 5—then the airplane started right up, and I taxied to the runway. I had a few odd tones on the takeoff roll but was busy with the departure—then I noticed that the airspeed was fluctuating and dropping wildly as I climbed out of the pattern. Not to worry—the airplane was flying just fine; I have a completely separate system for angle of attack (AoA) on this airplane (and it was rock solid and agreeing with the way the airplane was flying)—so I believed my groundspeed and the attitude of the airplane, set power, and headed home. I had to make a landing without airspeed—so it might as well be at home and not back on the ramp at Bishop!

The ugly remains of the bugs and their nest—a sure sign that you need to blow the system out backwards to clear the lines.

The safety wire came out after landing, and sure enough—I could feel a little resistance. The squeamish might not like hearing of the results when I pulled the safety wire out—brown goo and hints of tiny leg parts were left on the “snout” of the pitot. Clearly some Bishop local insects went home shopping while the airplane sat out, and I rudely interrupted their domestic tranquility as I rammed a hurricane into their living room—or, more likely, their nursery. The problem with probing from the front is that I was likely pushing debris back into the pitot lines—fortunately, I had a convenient breakout port at the wing root, so I introduced some shop air and watched debris pop out of the pitot tube, clearing the system.

Stuff like this happens—and it can happen easily overnight! It’s best to remember your pitot cover—but it is also not a bad idea to know how to fly your airplane with a faulty airspeed reading. If what you see on the gauge doesn’t make sense with what you feel and see out the windows, trust your instincts and declare the airspeed bad. In modern electronic flight instrument system (EFIS) equipment, this can sometimes affect other things, like attitude indications, so beware—only trust what you know. Few will build their airplanes with a redundant pitot probe for AoA (I test these systems, or I wouldn’t have a spare … ), but on a nice VFR day, loss of airspeed should be an annoyance, not an emergency. On a morning with low surface winds, GPS is a good approximation for airspeed in the pattern. Just add a few knots to make sure, don’t try to land on the shortest runway in your catalog, and just fly the airplane. And if you have never flown without airspeed—you now have an answer to your flight instructor when you’re asked what you’d like to do on your next flight review!

The post Bugs in the System appeared first on AvBrief.com.

Read the original source

Share this aviation story

Back to aviation news