The Smart Marty Sky Dispatch

Worldwide AviationSmartMarty.ca
General Aviation

On the Record: Jet EZ — Tennessee:

In-flight structural failure during a high-speed low pass.

On the Record: Jet EZ — Tennessee:
Featured aviation image for this report.

Overview of internal left wing structure. (NTSB)

September, 2018

The pilot was flying the Experimental/Amateur-Built airplane about 200 feet above ground level when its left wing failed, causing the airplane to abruptly depart controlled flight and subsequently impact terrain. Two witnesses indicated that the left wing began a flutter-like movement (described as an oscillation and a “wave like movement”/”wiggle”) immediately before the wing failed at its mid-span. The speed of the airplane at the time of the left wing failure could not be determined. However, a witness who had extensive experience observing the accident airplane during flight reported that the pilot performed an intentional low pass over the airport at a speed that may have been near the airplane’s maximum structural limits.

The NTSB’s Materials Laboratory examined portions of the internal left-wing material and found a lack of penetration and bonding of epoxy resin, which resulted in wing sections in which the adhesive had disbonded, leading to the wing’s failure. This finding indicated a fabrication problem during manufacture and not wear over time or an environmental degradation failure. It is likely that the airplane’s left wing entered a flutter condition during the high-speed low-pass maneuver and that the left wing’s internal composite structure near the wing’s mid-span subsequently experienced a failure of the adhesive between the composite layers.

NTSB Final Report

NTSB Docket

The lower surface of loose ply 5 at the spar cap location, showing “dry fiber” weave and globules of resin between the weave gaps. (NTSB)

Lower face of the ply 5, showing resin fracture away from the spar cap location. (NTSB)

The post On the Record: Jet EZ — Tennessee: appeared first on AvBrief.com.

Read the original source

Share this aviation story

Back to aviation news